Skip to content

Tower, Ground, Approach and Clearance Delivery: What Each Frequency Does

Ground moves aircraft on taxiways, tower handles runways and the airspace right around the airport, clearance delivery gives departure instructions, and approach and departure control guide aircraft to and from miles away.

The short version

A busy airport uses several radio frequencies, each for one job. The pilot switches between them as the flight moves from the gate to the runway and into the air.

FrequencyWhat it handlesYou hear
ATISA recorded weather and runway report, repeated all dayWind, altimeter, runways in use
Clearance deliveryThe route and departure instructionsPilots reading back a clearance
GroundAircraft moving on taxiways and rampsTaxi instructions
TowerRunways and the airspace next to the airportTakeoff and landing clearances
Approach and departureAircraft from about 5 to 40 miles outVectors, altitudes and handoffs
CenterAircraft flying between airportsHigh-altitude route traffic

Clearance delivery

Before a flight leaves, the pilot gets a clearance that spells out the route, the first altitude and a transponder code. At a busy airport this has its own frequency, so ground control isn't tied up. Airports without a clearance frequency give the clearance on ground control or by phone.

Ground control

Ground controllers direct aircraft and vehicles on taxiways. They don't clear anyone to take off or land; that is the tower's job. Ground is often the most active channel at a large airport, and the best place to hear what an airport is doing.

Tower

The tower controls the runways and the airspace right around the airport, typically within about five miles. Takeoff clearances, landing clearances and the order in which aircraft use a runway all come from the tower. Large airports have several tower frequencies, one for each runway or runway group.

Approach and departure

Approach and departure control run from a radar room, often called a TRACON, and handle aircraft from the edge of the tower's airspace out to about 40 miles. Approach brings arrivals in and hands them to the tower. Departure takes aircraft from the tower and sends them on their way. Many facilities use several frequencies split by direction or altitude. See the approach controls we list.

Center

Once an aircraft is on its route, it talks to an air route traffic control center. Each center covers a large region and uses many frequencies. See the control centers.

Frequently asked questions

Which frequency should I listen to first?

Start with the tower, which carries the takeoffs and landings, then add ground control and the ATIS. At an airport without a tower, use the CTAF.

Why can't I hear anything on a frequency?

Some airports have little traffic, towers close at night and many frequencies are only used for certain runways or hours. Try a different frequency or a busier time of day.