The basics
Civil air traffic control and airport communications use the VHF airband, 118 to 137 MHz, in AM (amplitude modulation) mode. This is different from police, fire and most other scanner traffic, which uses FM. If a frequency sounds silent or garbled, check that the mode is AM.
Military aircraft use a separate UHF band from 225 to 400 MHz, also AM. Our airport pages mark them as military UHF.
What you need
- A scanner that covers the airband, or a dedicated airband receiver. Almost every modern scanner does.
- An antenna suited to the band. The short flexible "rubber duck" that comes with a handheld works near an airport. A tuned airband or discone antenna gives better range.
- A frequency from the airport page.
Programming it
- Find your airport and pick a frequency, for example the tower.
- Set the radio's mode to AM.
- Enter the frequency. Most scanners take it as 120.750 (the page shows 120.75).
- Turn the squelch up until the hiss stops, then listen.
To follow a whole airport, program the ATIS, ground, tower and approach frequencies into one scan bank.
Range
VHF airband radio travels by line of sight. A handheld on the ground typically hears an airport tower from 10 to 30 miles away, depending on terrain. Aircraft hundreds of miles away can be heard at altitude on a good outdoor antenna.
Frequently asked questions
Why can't I hear aircraft, only the tower?
Controllers transmit from a high, strong site and aircraft from far weaker transmitters. Near the airport you'll hear both sides. Farther away you'll often hear only the tower or only the loudest aircraft.
Do I need a license to listen?
No license is needed in the United States to receive airband radio. Transmitting does require a license and training.