Skip to content

CTAF and UNICOM: Radio at Airports Without a Tower

At an airport without a control tower, pilots announce where they are on a shared frequency called the CTAF, and a UNICOM operator, if there is one, answers questions about fuel and services. Both are usually between 122.7 and 123.075 MHz.

What CTAF means

CTAF stands for common traffic advisory frequency. At an airport with no control tower, or when the tower is closed, pilots use it to tell each other where they are and what they plan to do: "Smithville traffic, Cessna 123, ten miles south, inbound to land, runway 18." Nobody controls the traffic; the pilots sort it out between themselves.

What UNICOM means

UNICOM is an air-to-ground service run by a person at the airport, often a fuel or flight-school employee. Pilots call it to ask about fuel, parking, ground transportation and the runway in use. At many airports UNICOM and CTAF are the same frequency.

Which frequencies are used

Most small airports use one of a handful of frequencies:

  • 122.8 MHz and 122.9 MHz: the most common CTAF channels at uncontrolled airports.
  • 122.7 MHz, 122.725 MHz and 123.0 MHz: other common CTAF channels.
  • 122.95 MHz, 122.975 MHz and 123.05 MHz: also used for UNICOM at some airports.

Because so many airports share them, a scanner listening to 122.8 near several small airports may hear all of them.

How to listen

Set your scanner or airband radio to AM mode and enter the frequency listed on the airport's page. Traffic at small fields is bursty: you might hear nothing for several minutes, then several aircraft in a row.

Frequently asked questions

Is there anyone controlling traffic on CTAF?

No. CTAF is a way for pilots to coordinate with each other. If a UNICOM operator is there, they may give advice, but they aren't an air traffic controller.

What happens when a tower closes?

At many airports the tower frequency becomes the CTAF when the tower is closed, and the airport reverts to the same self-announce procedure.