Skip to content

Barker Field (NR76) Frequencies

Barker Field (NR76) is a private-use airport 3 nautical miles southeast of Linden, North Carolina. It has no control tower; pilots announce on the CTAF, 122.90 MHz.

Quick answer: Barker Field frequencies

  • CTAF 122.90 MHz

FAA data cycle effective October 29, 2026. Verify against a current chart before flying.

About Barker Field

  • 1 radio frequency is listed for Barker Field by the FAA.
  • No control tower: traffic is uncontrolled and pilots self-announce.
  • 1 runway, the longest 1,300 ft (12/30).
  • Field elevation 105 ft above sea level.
  • Responsible air route traffic control center: ZDC.

Barker Field radio frequencies

Air traffic control and airport communications use the VHF aircraft band (118 to 137 MHz) in AM mode.

CTAF

CTAF
Frequency (MHz)Service
122.90 CTAF

Barker Field runways

Runways at Barker Field
RunwayLengthWidthSurfaceLightingInstrument approach and pattern
12/30 1,300 ft 80 ft Turf (fair)

FAA remarks

  • Owner desires airport be charted.
  • 35 feet tel pole, with plines marked with two orange balls, imt off the airstrip, on the runway 30 ctr. If LDG runway 30, pilots should offset their td point to halfway down the runway to avoid the tel pole. Runway 12 pref for LDG.
  • 35 feet tel pole, with a guy wire marked by an orange ball, imt off the sw corner of runway 12, on the pilots right drg runway 12 approach.

Location and details

Identifier
NR76
Type
Airport, private use
Location
Linden, Cumberland County, North Carolina
Coordinates
35.2303, -78.7072
Elevation
105 ft
Control tower
No
Controlling facilities
Washington Center

Frequently asked questions

What is the CTAF frequency for Barker Field?

The common traffic advisory frequency (CTAF) for Barker Field is 122.90 MHz. Confirm on a current chart before flying; frequencies can change.

How many runways does Barker Field have?

Barker Field has 1 runway: 12/30 (1,300 by 80 ft).

What is the elevation of Barker Field?

Barker Field is 105 feet above sea level.

Can I listen to Barker Field on a scanner?

Yes. Air traffic control and airport communications use the VHF aircraft band, 118 to 137 MHz, in AM mode. Most scanners and handheld airband radios can receive it; set the mode to AM and enter the frequency.

Airports near Barker Field